Man I had a pair of the chinese ones when i was in high school and they were so mismatched and noisy. It was before people realized that there were in fact chinese ones around. I tried so many different things before just getting rid of them. They left a bad taste in my mouth, despite hearing amazin...

Ribbon:Altec 670bAiwa VM-15Beyer m130 (2)Beyer m160 (2)Beyer m500 (4)General Electric Ribbon (made for ORTF)RCA 44BX (2)RCA 74Dynamic:Altec 633AAKG d190AKG d200e (2)Audio Technica ATM25 (3)Beyer m201 (3)Beyer m380Electro Voice 635AElectro Voice 666Electro Voice RE-10 (3)Electrovoice RE-16Electro Voi...

THANKS GREG!

shitthe same seller has panel mount female connectors, I bet i could make a cable with that.

I'm looking to source some of the male and female connectors for the 150s.I have mics and Power supplies, but only one cable.Any ideas where I can look?

these are the correct male ends, right?https://www.ebay.com/itm/Vintage-Rare-NOS-Cannon-P8-CG-12S-Altec-M11-Microphone-Connectors-8-Pin-/302523226255

Get a moon gel, or the toy equivalent, and cut of a small piece.Place it directly where the mic is pointed and adjust size and position of moon gel for desired effect.This is a case of something sounding drastically different mic'd than it does in the room, so really check your signal on monitors be...

+1The interns I used to accept from rock and roll school used to shout more bass broseph!! from the back of the room. Oooh oooh oooh. One grabbed an amp off the bench that had no tubes in it and turned it on.I don't really do interns anymore, save for

my bx44 couldn't handle the low end of an upright bass with the proximity required. I used a fat head with a lundahl and I'm extremely happy with the soundsidenote: gefell m300s are awesome.

I've got a problem I can't figure out.I'm hearing a pretty significant amount of flutter from one of out a810s.Also, when I tell it to fast forward, it starts slow slowly speeds up.Any ideas?