Hello all.I just got a microphone geffel mv692.I have and its transformer connectors.However, I miss a NS104 via XLR cable.With it, how to proceed with welding?Thank you for your help

hello.nobody could help me, I find it on the netthank you

I'm a little unsure what you're asking, but I assume you are trying to build an adaptor to connect the original connector to a standard XLR. I googled "Gefell MV692 Schematic" and found this page. Both sets of schematics are there. It looks like you will have to do more than make an adaptor cable. There might be additional internal modifications. I recommend contacting Gefell directly to get the proper upgrade. They still support this mic.Good luck,Greg

hello,I can not test the microphone if I did not connect a cable xlr.Or find plans (schematics) for welding this one.thank you again

I'm Confused then,Please ask your question en français. Our international department (Gregoire) will help you.

thank you gregit's not that.Just how the welded wire

Agreed. I had my 692 48 volted/XLRed by MTG a few years ago, couldn't be happier.

melvins111 wrote:okje possède pour ce microphone le transformateur et le câble qui le relie.il me manque l'autre cable qui se termine en xlr.IL faudrais que je fabrique le cable qui relie le xlr. avec ceci que je possède:http://cgi.ebay.fr/36-VEB-MIKROTECH-GEF ... 20c45a9723je voudrais le souder et pas faire n'importe quoi.je ne trouve pas de schéma sur le net.Merci a tousOK, so melvins111 has a MV692 with a power supply. He has the cable to connect the mic to the power supply and he is looking for a wiring diagram to make a cable from the power supply to an XLR connector. In order to do that, he has already bought a 7-pin connector that connects to the power supply.Here are two things that I found online:N692 manual48V adapter wiring diagram (look at the very bottom of the page)Greg Norman recommends that you contact Microtech Geffel directly so they can explain to you how to do that. Any help is appreciated!PS: si tu as du mal à comprendre ma réponse en anglais tu peux m'envoyer un message perso en francais, à plus!

Salut melvins111, si je comprends bien tu as le micro, le boitier d'alimentation, et le cable qui relie le micro au boitier d'alimentation. Il te manque donc le cable qui relie le boitier d'alimentation au XLR. C'est ça?Dis moi si c'est ça et je vais traduire ton problème pour que les gens du forum puissent t'aider, merci et à bientôt!Grégoire

bingo, c'est exactement çail faudrais quer je sache comment souder le câble qu'il me manque.Ps: desoler pour le non anglais et surtout grand merci a vous