One Tone Press

1
Hi, i'd like to share our band, we release our first song yesterday !


It's 100% DIY, recorded, mixed and mastered by ourselves at a friend's place in the countryside near Grenoble (in france), and then the video was shot in the pyrenees, in the batcave of an other friend.

it's a sort of industrial punk coldwave (because there are lots of synths). The industrial side is due to the fact that we recorded drum samples at our singer's workshop, he is a black smith : I was a bit scared for my microphone when soldering next to it but it turned out fine and we use a lot those samples. Here are some pictures

Soudure-min.png
Soudure-min.png (140.31 KiB) Viewed 368 times
tole-min.png
tole-min.png (151.3 KiB) Viewed 368 times
Raclure-min.png
Raclure-min.png (155.99 KiB) Viewed 368 times
hope you like it !

Re: One Tone Press

2
Some other pictures of the recording :

we used two different bass amps and the signal was split. One was an ampeg svt3 and the other one a Sunn. I don't know if it was such a great idea because at the end we ended up using mainly the ampeg.

But next to us in the building where we recorded was an Aikido club, so we borrowed some tatamis and big matresses to build "cabins" to isolate our amps.
Ampli bass split.jpg
Ampli bass split.jpg (54.41 KiB) Viewed 367 times
Then to minimize the acoustics when recording the vocals, we built a cabin with those same matresses and tatamis and some theatre curtains.
cabine2.jpg
cabine2.jpg (79.55 KiB) Viewed 367 times
Cabine 3.jpg
Cabine 3.jpg (50.65 KiB) Viewed 367 times

The drums and synth were recorded directly straight into the soundcard.
But then we reamped the drums going through the bass amp in this big concrete room, and placed a couple of room mics to have the stereo ambiant sound (which we then delayed a little bit, thanks for the trick steve albini!).

We reamped some of the synths as well but didn't have time to do it all and sometimes it was deceiving.

Who is online

Users browsing this forum: No registered users and 0 guests