Re: A Few New Projects
132Body update: oil finish is complete- about 12 coats of tru-oil (BLO w/ a dryer). #600 between coats at the beginning, #0000 steel wool for the last few.
- Attachments
-
- DSC05522.JPG (147.11 KiB) Viewed 345 times
-
- DSC05521.JPG (166.39 KiB) Viewed 345 times
Re: A Few New Projects
133Neck update: Got the 1/8" spacers for both the tuners and under the fretboard epoxied on and tuners drilled
- Attachments
-
- DSC05460.JPG (136.84 KiB) Viewed 345 times
-
- DSC05459.JPG (108.33 KiB) Viewed 345 times
-
- DSC05458.JPG (152.96 KiB) Viewed 345 times
Re: A Few New Projects
134neck update, pt 2: Did a lot of reshaping and cleaning up the width to match the fretboard (it was close, but not perfect before). Then epoxied on the fretboard. obviously lots of filing and sanding/polishing to do...but getting there.
- Attachments
-
- DSC05523.JPG (165.3 KiB) Viewed 344 times
-
- DSC05462.JPG (117.74 KiB) Viewed 344 times
-
- DSC05461.JPG (163.16 KiB) Viewed 344 times
Re: A Few New Projects
135Any plans to do any w/ an aluminum fretboard? I imagine laying fretwire into metal is a different challenge.
Re: A Few New Projects
136I would like to give this a shot at some point. Major concern is putting a radius on the board, which is probably easy w/ cnc, but non-trivial by hand.
Re: A Few New Projects
137first sort of mock up- board attachment went smoothly. spend an hour this evening just sanding and shaping-
- Attachments
-
- DSC05524.JPG (174.95 KiB) Viewed 253 times
Re: A Few New Projects
140I figured it was demo carpet samplesDudley wrote: Wed Apr 27, 2022 7:22 amYeah! I need explanation. Are those calibrations? Is it a triffid scale?